top of page
Andrew McDowell

Andrew McDowell

3D printed passive shims for permanent magnets: Application to iron-pole, Halbach arrays, and a unique tilted field magnet

Magnetically soft materials offer significant advantages over hard materials for implementing passive shims. In previous work, we have leveraged the ease of handling, the high precision and accuracy, and the low cost of magnetic ink to shim high-performance iron-pole magnets to sub ppm homogeneity.

For lower homogeneity magnets, for example those designed for time-domain measurements, the ink is not magnetically strong enough. For these magnets, we have been using 3D printed magnetic filament to achieve field improvements. We have found that readily available filament and a mid-level 3D printer are more than adequate for producing passive shims that substantially improve homogeneity. The precision is high enough that it is worthwhile to develop custom slicing software to drive the printer, thereby enabling improved accuracy in producing the calculated shim design.

We have applied 3D printed passive shims in a 0.3 T, 60 mm gap iron-pole magnet from Fine Instrument Technology (Brazil), reducing the peak-to-peak field variation over a 40 mm diameter sphere from 570 to 220 ppm. The final field error is almost entirely due to a Z6 field, which is of high enough mathematical order that it has minimal impact on the NMR signal.

Halbach array/ring magnets can also be shimmed this way. For two magnets with 40 mm bores, we have achieved improvement over a 40 mm diameter sphere from 5625 to 221 ppm at 0.5 T and 400 to 14 ppm at 1.4T.

Presently, we are applying our methods to a 0.08 T cylindrical magnet from RE Magnet Studio, Ltd. that has a field pointing at 54.7 degrees with respect to the cylinder axis. We discuss the challenges of designing shims for such a magnet and (time permitting) the resulting homogeneity improvement.

​

1) A.F. McDowell and R.R. Lown, "Designing and shimming Halbach Array magnets," JMR Open, submitted.

bottom of page